Standard Programming; Important - Dea LIVI Serie Instrucciones De Uso Y Advertencias

6 STANDARD PROGRAMMING

1 Power Supply
Give power supply, the display shows the following symbols "
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START command
is given, the position reset procedure is performed (see "rESP" in the table "WORKING STATUS MESSAGES" on page 34.
2 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the
screen reads P013;
2. Access the parameter by pressing the
3. The "Input Status" is shown on the screen (check that
this is correct):
4. Press the button again;
5. The "Total Operation Counter" is shown on the screen
(* see P064):
Ex: = 3x1000* = 3000 operations executed
6. Press the button again;
7. The "Maintenance Operation Counter" is shown on the
screen (* see P065):
Ex: = 5*x500 = 2500 operations still to be car-
ried out before the maintenance intervention request (
= maintenance operation counter disabled)
8. Press the button again to exit the parameters (P013
is shown on the screen again).
3 Selection type of operators
1. Scroll down the parameters with
P028;
2. Access the parameter by pressing the
3. Acting on and
- d005 = LIVI 5/24 - 6NET
- d006 = LIVI 8/24 - 9NET
4. Confirm your choice by pressing the
P028).
4 Selection of direction of motion
1. Scroll down the parameters with
until you visualise P063;
2. Access the parameter by pressing the
3. Acting on and
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Confirm your choice by pressing the
returns again to P063).
Warning: The parameter automatically reverses the
motors output open/close and any limit switch input
open/close.
28
and keys until the
button;

! IMPORTANT !

and keys until you visualise
key;
keys, set:
key (display returns again to
and keys
key;
keys, set:
key (display
", " ", " " and then "- - - - ".