Carrier 38VT008173HQEE Manual De Instalación Y Propietario página 14

Installation Instruction
Outdoor Unit Installation
Standard accessories
Please check the attachment is complete.
No. Definition
1 Installation
instruction
2 Rubber plug
3 Sheath
4 Reducing pipe
5 Wiring harness
1. For installation, choose a place that can bear the weight of the unit so that the unit will not shake or fall. The unit should be
installed on a flat area (below 1/100).
2. Do not install the unit in areas of flammable, explosive, or corrosive gas leakage.
3. The indoor and outdoor machines should be as close to each other as possible to reduce the length of the refrigerant pipeline
and the number of bends.
4. The installation of the unit should be in places shielded from sun and rain, dust, typhoons, and earthquakes. In snowy
locations, the machine should be installed in the frame or under snow cover, so as to avoid the machine getting clogged with
snow (see Figure 1).
5. Make sure there is enough room for carrying out maintenance.
6. Measures should be taken to avoid contact with children.
7. When routing the refrigerant pipe below the unit the unit should be raised at least 200mm
Snow cover (customer)
Wind shield (customer)
Seasonal wind
The base height should be
determined by the maximum local
snowfall. Snow height should not
exceed the unit angle.
Graphic
Figure 1
Quantity
1
1 Signal line protection
1 Power line protection
BHP: 2
10HP: 3
12HP: 1
14HP: 1
4 Gas liquid pipe insulation
Please use M12 fixed anchor bolts, four for each machine, and use shock
absorbers or cushions to reduce noise.
7
Remarks Place position
Accessory bag
Accessory bag
Accessory bag
Reducing pipe Accessory bag
Accessory bag
binding
Figure 2
Aerial part
height above
200mm