Recommended Spare Parts; Storing The Machine; Troubleshooting - BM2 BIEMMEDUE SWEEP Manual De Uso Y Mantenimiento

8.5

Recommended spare parts

To guarantee efficient maintenance, the Manufacturer recommends
that only the original spare parts listed in the annexed spare parts
booklet should be used. When ordering spare parts, specify the
model of the machine, registration number, reference number of the
component in the spare parts book and quantity.
8.6

Storing the machine

If the machine is not used for long periods:

Remove the brush;

Store the machine in a dry place, protecting it from dust.

Protect exposed parts (not protected by paint, surface
treatment or plastic) with protective rust prevention oils.

Charge then disconnect the battery.

After performing these operations, seal the machine inside
an opaque black multilayer nylon bag together with a
suitable drying agent (silica gel).
9 Disposal
9.1 Disposal
At the end of its useful life, you have to scrap and dispose of this
product by taking it to a local differentiated waste collection center in
conformity to law. Before scrapping, check the serial number plate
on the machine: if it has the symbol
regulated by EU Directive 2003/96 (Waste Electrical and Electronic
Equipment, WAEE). The user must inquire about the local electrical
and electronic waste collection system and follow its instructions.
Illegal disposal of this product with normal domestic waste can
seriously harm the environment and health and is subject to
administrative penalties.
10 Table of regular maintenance
OPERATION
Check the functioning of all
controls
Check the battery fluid
Charge the batteries
Check the tightness of screws
and nuts
Check the condition of the brush
11

Troubleshooting

The table below gives the most common problems which may arise
during normal use of the MOTORISED SWEEPER. These problems
are easy to resolve with operations classified as routine
maintenance If the problem is not present in the following table or
cannot be eliminated following the instructions here, contact an
authorised service centre.
PROBLEM CAUSE
The brush does not The brush is broken
turn
Electrical
mechanical problem
, it means that disposal is
X
X X
X X
X
X
SOLUTION
Replace the brush
or Contact
authorised
centre
an
service