Safety Parameters - BM2 BIEMMEDUE SWEEP Manual De Uso Y Mantenimiento

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

2.6

Incorrect or improper use

The machine is designed for use exclusively for the purposes and in

the areas described in the relevant section of the manual. Use other

than those described in this manual is considered incorrect or

improper and therefore not in conformity with safety regulations.

IMPORTANT: Incorrect or improper use of the

machine could cause personal injury, death and/or

damage to the machine or equipment.

Examples of possible incorrect or improper use which could cause

personal injury or damage to the machine and other equipment are

given below:



Unauthorised modification or replacement of parts of

the machine;



Failure to observe the safety instructions;



Failure to observe the installation, use, operation,

maintenance and repair instructions or performance

of these operations by unqualified personnel;



Use on unsuitable and incompatible surfaces.

Operation and technical specification

3.1

Operating the machine

The MOTORISED SWEEPER is a professional appliance designed to

sweep and clean dry industrial floors or asphalted surfaces

(warehouses, outdoor and multi-storey car parks, laboratories in general,

service stations, sports centres, camp sites and holiday villages, hotels,

supermarkets, workshops) to remove solid material only, such as dust,

soil, paper or similar by means of a brush outside the frame of the

appliance. The machine moves the debris to the side to be picked up by

other means. The machine consists of the following elements:



Welded folded steel chassis;



Brush;



Brush rotation motor;



Operator handlebar with controls.

The MOTORISED SWEEPER is represented in the following figure.

In the manual, the sides of the machine will be referred to from the

point of view of the operator holding the handlebar with controls.

3.2

Conditions of use

The MOTORISED SWEEPER has been designed to perform the

functions described in the section of this manual only. The machine

must be used in environments conforming to those described in

section on admissible environmental values.

3.3

Technical specification of the machine

3.3.1

Weight and size

The weights and sizes of the MOTORISED SWEEPER are given in

the following tables.

Weight

Empty weight (without batteries)

Mass (with batteries)

Dimensions

Le min. (Maximum length)

Max. Wdth. (Maximum width)

Min. H (Maximum height)

3.3.2

The machine is powered by a 12 V battery. The electric motor turns

the brush.

The work parameters provide the information necessary to choose

the most suitable machine for the specific needs.

*: on request, brushes made from different materials can be fitted for

particular applications: contact the Manufacturer or dealer.

In normal working conditions, there are no residual risks.

There are, however, residual risks always present during normal

working conditions exclusively in danger zones where access is

prevented by means of fixed guards. These guards must under no

circumstances be removed while the machine is in operation.

Guards on transmission components may be temporarily removed in

order to carry out adjustments or routine or extraordinary

maintenance (for extraordinary maintenance, always contact a

professional service centre). The residual risks arising under these

conditions may be eliminated by adopting certain procedures. When

using the machine, the operator must hold the handlebar within

reach of all operating controls and with an adequate view of the path

of the machine in order to avoid impact with obstacles (danger of

tipping over) and people (injury to persons).

Lp dB(A) 89 (uncertainly 1,5) - Lw dB(A) 96

Reference Standard EN60335-2-79

The vibrations produced are minimal and do not represent a source

of danger for the operator. The levels have, however, been

determined in accordance with ISO 5349.

No particular procedures must be adopted in order to

safeguard the operator from the effects of the vibrations

produced. In the event of abnormal vibrations, the operator

should immediately stop the machine and contact maintenance

personnel.

1300

600

850

Power supply and motor power

3.4

Work parameters

Parameters

Maximum theoretical productivity

/h)

Motor power

Diameter of centre brush (mm)

Brush material*