Recommended Spare Parts - BM2 BIEMMEDUE DUSTY 650 M Manual De Uso Y Mantenimiento

Routine maintenance
Replacing the side brush belt
The movement is transmitted to the side brush by means of a belt
from a pulley attached to the right wheel of the sweeper. To replace
in the event of wear:
Remove the pulley guard by unscrewing the fixing knob.
•
Tilt the side brush support and remove the belt from the
•
two pulleys.
Adjusting the height of the centre brush
To adjust the height of the centre brush, use the knob on the top of
the sweeper.
Replacing the side brush
When the side brush is worn, it can be replaced following the
procedure in paragraph "Installation" describing mounting of the side
brush.
Replacing the centre brush
To replace the centre brush, follow this procedure:
Remove the rear debris collection bin;
•
Tilt the sweeper;
•
Rotate the brush until you can see the two hex head
•
screws fixing it to the drive mechanisms;
Unscrew the screws;
•
Fixing knob
Pulley guard
Side brush support
Pulley
Belt
Centre brush height
adjustment knob
Remove the brush;
•
Insert the new brush, making sure it fits on the drive
•
mechanisms and tightening the lock screws.
Flaps
After removing the debris collection bin, tilt the sweeper. Replace
the flaps:
Unscrew the screws fixing the flap retainer to the chassis
•
of the sweeper;
Remove the flap retainer;
•
Replace the worn flap with the new one;
•
Replace the flap retainer and fasten in place with the
•
screws removed previously.
Flap retainer
Fixing screws
Remove the fixing screws;
•
Replace the worn flap with the new one;
•
Replace the flap retainer and fasten with the screws;
•
Replace the flap raising cable.
•

Recommended spare parts

To guarantee efficient maintenance, the Manufacturer recommends
that only the original spare parts listed in the annexed spare parts
booklet should be used.
Brush fixing
screws
Drive mechanisms
Slot for the drive
mechanisms on
the brush