Gigaset A510-A510A / USA en / A31008-M2202-R301-1-3S19 / starting.fm / 25.08.2011
First steps
14
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully
charged and discharged.
¤ Charge the handset in the base for 6 hours.
Please note
The handset must only be placed in the designated Gigaset A510/A510A base
or charger.
¤ After charging, remove the handset from the base and only replace it when the
batteries are fully discharged.
Please note
u The handset is pre-registered with the base. If you have purchased a model
with multiple handsets, all handsets will already be registered with the
base. You do not need to register the handset again.
However, if a handset is not registered with the base (Register handset or
Place handset in base flashes on the display), please register the handset
manually ¢ page 42.
u After the first battery charge and discharge, you may place your handset in
the charger after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.
If you have any questions about using your phone, please read the tips
on troubleshooting (¢ page 55) or contact our Customer Care team
(¢ page 52).
6h