Energy Star - Lexmark Optra C710 Guía De Usuario

Energy Star

Electronic emissions
notices
Without a network adapter
E
The EPA ENERGY STAR Computers program is a partnership effort with computer
manufacturers to promote the introduction of energy-efficient products and to reduce
air pollution caused by power generation.
Companies participating in this program introduce personal computers, printers,
monitors, or fax machines that power down when they are not being used. This feature
will cut the energy used by up to 50 percent. Lexmark is proud to be a participant in this
program.
As an Energy Star Partner, Lexmark International, Inc. has determined that this product
meets the Energy Star guidelines for energy efficiency.
Electronic emission information for your printer varies, depending on whether or not
you have an optional network adapter installed.
Federal Communications Commission (FCC) compliance
installed information statement
Your Lexmark Optra C710 color laser printer has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult your point of purchase or service representative for additional
suggestions.
Noticias
Apéndice E: Noticias
237