In this case, immediately disconnect the compressed air
hose from the tacker.
Opening the magazine
To open the magazine (6), push the locking mechanism (4)
forwards in the direction of the arrow.
Pull out the lateral slider at the lock (5) towards the rear.
Inserting fasteners
To insert the fasteners (14) in the magazine, tilt the tacker to the
side and insert the strips into the magazine with the crown
upwards (type: ALK).
Make sure that the tip of the printed arrow (type: AL) on the
fastener is pointing downwards.
Push the fasteners as far as they will go to the left into the inlet.
WARNING
Risk of explosion if the maximum operating
pressure is exceeded.
Preparing the tacker
17