Waeco MagicWatch MWE150 Instrucciones De Montaje Y De Uso página 31

MWE-150-2.book Seite 31 Freitag, 3. Februar 2006 4:52 16
All manuals and user guides at all-guides.com
MagicWatch MWE150
For making and testing the electrical connection the following tools are re-
quired:
Diode test lamp (1 5, page 3) or Voltmeter (1 6, page 3)
Crimping tool (1 7, page 3)
Insulating tape (1 8, page 3)
Cable bushing sleeves, if required
To secure the controller and the cable you may require additional screws
and cable binders.
6.2 Fitting the sensors
Note
The sensors must be correctly aligned for the device to work.
If these point to the ground, bumps in the ground may be
interpreted as obstacles. If they point too far up, obstacles will not
be detected.
Note the following information during installation:
The maximum range is approximately 1.5 m.
For the optimum monitoring of the rear of the vehicle, the two sensors
should not be mounted more than 60 cm away from one another.
The distance from the sensors to the ground must be between 40 cm and
50 cm (0, page 6).
The installation location should be as flat as possible so that the cover ring
of the sensor is on the bumper.
The sensor is preset to have a vertical installation angle of
approximately +5°. This means that the cover ring is thicker at the
bottom.
Note that the sensors must be aligned in a particular direction. The top of
the sensor is marked with a ▼ (a 1, page 6).
It is possible to paint the sensors, but not with a multicoat paint, as it
impairs the functionality of the sensors.
Installing MagicWatch
31