Testing Functions - Waeco MagicWatch MWE150 Instrucciones De Montaje Y De Uso

MWE-150-2.book Seite 36 Freitag, 3. Februar 2006 4:52 16
All manuals and user guides at all-guides.com

Testing functions

7 Testing functions
Conduct the functional test as follows:
➤ Switch on the ignition and engage reverse gear.
Be very careful when you first operate the device, and make sure you get to
know the various sequences of beeps.
Zone Description (5, page 5)
1
MagicWatch recognises obstacles from a
distance of around 1.5 m (measured from
the sensor) and signals them with a series
of slow beeps from the speaker.
2
From a distance of around 0.95 m
(measured from the sensor)
MAGIC WATCH switches to the medium
sequence.
3
At a distance of around 0.4 m (measured
from the sensor) and below, MagicWatch
switches to the continuous tone. When you
reach this zone, stop the vehicle.
Otherwise you might damage the vehicle
or the obstacle.
Caution!
In Zone 3 it can occur that obstacles are not detected, because
they are no longer within range of the sensors (depending on de-
sign).
The device is equipped with a diagnostic function: If the sensors are defecti-
ve, you will hear three short beeps when you engage reverse gear.
36
MagicWatch MWE150
Sound sequence
Beep Beep
Beep Beep
Beep Beep Beep
Beep Beep Beep
Beeeeep...