Kit Assembly - Metra 99-6523 Instrucciones De Instalación

ISO DIN radio provision
with pocket
1. Position the radio mounting
brackets into the sub dash opening
and secure with the (2) Phillips
screws removed in disassembly.
(Figure A)
2. Attach the (4) panels clips to the
radio trim panel. (Figure B)
3. Mount the pocket to the radio
brackets with (2) #8 x 3/8" screws
supplied. Note: Pins on brackets
will align with front mounting
hole of pocket. (Figure C)
(Figure A)

Kit Assembly

(Figure B)
(Figure C)
99-6523
4. Attach the radio bracket/pocket
assembly to the aftermarket
radio using the screws supplied
with the radio or the supplied (4)
Phillips screws. Note: Screws
must not protrude from slot in
radio brackets as interference
with mounting bracket will
occur when sliding radio into
mounting brackets. (Figure D)
5. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
6. Slide the aftermarket radio/pocket
assembly into the radio opening
between the radio mounting
brackets until it clips into the
opening. (Figure E)
7. Snap the radio trim panel into
the opening around the
aftermarket radio.
3
(Figure D)
(Figure E)