Adjusting The Broom Side Angle - Toro 38701 Manual De Instrucciones

WARNING
Contact with a rotating broom can result
in serious personal injury or death to the
operator or bystanders.
• To remove an obstruction from the broom;
refer to Clearing a Clogged Broom (page
16).
• Do not operate the machine if the broom
drive lever is not functioning properly.
Contact your Authorized Service Dealer.
WARNING
The rotating broom can throw stones and
other foreign objects, causing serious
personal injury to you or bystanders.
• Keep the working area clear and free of all
objects that the broom could pick up and
throw.
• Keep all children and pets away from the
area of operation.
CAUTION
When the broom is engaged, it may drive the
machine in the reverse direction. If the broom
height is adjusted too low, the machine may
move more forcefully in the reverse direction,
causing injury and/or property damage.
Carefully check the broom height and adjust
it properly or contact your Authorized Service
Dealer.
1. Set the engine throttle to the F
2. Place the speed selector lever into the desired
position and slowly squeeze the left hand
traction drive lever.
Important:
Make sure that the traction drive
is engaged before operating the broom;
otherwise, the broom may drive the machine
in the reverse direction.
3. Engage the broom by slowly squeezing the right
broom lever to the handle
position.
AST
(Figure 19).
•
If the engine slows down under a load or the
wheels slip, shift the machine into a lower
gear.
•
If the front of the machine rides up, shift
the machine into a lower gear. If the front
continues to ride up, lift the handles.
4. To stop the broom, release the right lever.
Adjusting the Broom Side
Angle
1. Disengage the broom and shut off the engine.
2. Wait for all moving parts to stop.
3. Push the lever down with the thumb of your right
hand (Figure 20).
4. Squeeze the left wheel-clutch lever to the handle
(Figure 20) and push the broom housing to
following positions.
15
Figure 19
Figure 20
g326523
g326519