Lubrication; Engine Maintenance; Servicing The Air Cleaner - Toro 38701 Manual De Instrucciones

1. Spark-plug wire

Lubrication

Lubricating the Broom-Angle-Lock
Pin and the Hex Shaft
Service Interval: Every 100 hours
Yearly
1. Lubricate the broom-angle-lock pin fitting with
No. 2 lithium grease
1. Broom-angle-lock pin
Figure 22
(Figure 23).
Figure 23
2. Remove the belt cover and the engine shield.
3. Move the speed-selector lever to the R2 position.
4. Dip a long, clean, small-tipped paint brush in
automotive engine oil and lightly lubricate the
hex shaft
Important:
wheel or the aluminum friction-drive plate as
the traction drive will slip
Note:
Rock the machine forward and rearward
to rotate the hex shaft.
g023810
1. Aluminum friction-drive
plate
5. Move the speed selector lever to position 6.
6. Lubricate the other end of the hex shaft.
7. Move the speed selector lever forward and
rearward a few times.
8. Install the belt cover and the engine shield.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Every 50 hours—Clean the foam
Every 200 hours—Replace the foam
pre-cleaner.
Every 300 hours—Replace the paper air filter
(more frequently in dusty conditions).
Important:
Do not operate the engine without the
air filter assembly; extreme engine damage may
g325097
occur.
1. Release the latches on the cover for the air
cleaner.
19
(Figure 24).
Do not get oil on the rubber
(Figure
Figure 24
2. Hex shaft
pre-cleaner (more frequently in
dusty conditions).
24).
g325104