Radio Code Programming (For Rsd Only) - Erreka PUMA PUS400EC Manual Del Instalador

3

RADIO CODE PROGRAMMING (FOR RSD ONLY)


When using the ERREKA RSD plug-in receiver (decoder-free receiver, trinary code, 433Mhz), the radio code can
be programmed in the control panel itself, as explained below. In other cases, follow the instructions of the plug-
in receiver used.

The programming of the radio in total and pedestrian opening are independent. Different transmitters can be
used with different codes.
Total opening code programming
Pedestrian opening code programming
All manuals and user guides at all-guides.com
1 Connect the control panel power supply (SW1 in
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP4 in "ON"; DIP2, DIP3, DIP5 and
4 Select the required code in the transmitter.
5 Press the channel to be used for total opening.
6 Place DIP1 and DIP4 in "OFF" (DL2 and DL3 will go
7 Disconnect and reconnect the panel power supply.
1 Connect the control panel power supply (SW1 in
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP6 in "ON"; DIP2, DIP3, DIP4 and
4 Select the required code in the transmitter.
5 Press the channel to be used for pedestrian opening.
6 Place DIP1 and DIP6 in "OFF" (DL2 and DL3 will go
7 Disconnect and reconnect the panel power supply.
PROGRAMMING AND STARTUP
ON).
DIP6 in "OFF".

DL3 lights up.

If programming has been carried out correctly,
DL2 flashes.
off).
ON).
DIP5 in "OFF".

DL3 lights up.

If programming has been carried out correctly,
DL2 flashes.
off).
PUMA operator for sliding gates
55