Pedestrian Open/Close Programming; Selection Of Modes And Control Panel Functions (Sw) - Erreka PUMA PUS400EC Manual Del Instalador

5

PEDESTRIAN OPEN/CLOSE PROGRAMMING

Start programming mode
Programme the slowdown start points
Finish the programming mode

The pedestrian opening and closing of the gate
will be memorised.

The positions in which the gate begins to slow
down, both on opening and in closing, will also
be memorised.
6

SELECTION OF MODES AND CONTROL PANEL FUNCTIONS (SW)


Using SW2, choose the required options (see "SW2 functions" on page 54).
All manuals and user guides at all-guides.com
1 Ensure that DIP9 is configured correctly (see "Limit
2 Close the gate by pressing PUL1.
3 Place DIP7 in "ON" to enable the encoder.
4 Place DIP8 in "ON" (slowdown).
5 Place DIP1 and DIP3 in "ON"; DIP2, DIP4, DIP5 and
1 Start to open the gate: press ST2; the gate begins
2 Start slowdown in opening: press ST2 (or A.P. or
3 Finish the pedestrian opening: press ST2 at the
4 Start closing the gate: press ST2; the gate begins
5 Start slowdown in closing: press ST2 (or A.P. or
6 Wait for the gate to come to a halt due to the
1 Place DIP1 and DIP3 in "OFF".
PROGRAMMING AND STARTUP
switches configuration (DIP9)" on page 53).

If the encoder is not enabled (DIP7=OFF),
operation times will be memorised.
DIP6 in "OFF".

DL3 lights up, indicating
programming mode.
to open.
the transmitter) at the point chosen for the start of
slowdown (DA1).
required position for the end of pedestrian opening.
to close.
the transmitter) at the point chosen for the start of
slowdown (DC1).
action of the closing limit switch.

DL3 will remain off.
PUMA operator for sliding gates
that it is in
57