Maclaren quest Manual De Instrucciones página 7

10 REMOVING AND REFITTING THE SEAT COVER
Remove hood, shoulder pads from buggy if fitted.
Using foot, lift the brake pedal, then press down on
the lever sticking out on the right side of the frame.
A Twist shoulder strap end buckles and feed
through holes.
B The waist harness back strap is fixed to the
chassis behind the seat. To remove, twist strap
buckle and feed up through seat base and
liner holes.
C Feed crotch strap buckle through holes.
D Unclip seat cover retaining straps.
E Unfasten seat fabric from handle tubes and
seat base.
F Slide fabric from seat back and base.
G When refitting seat fabric, insert seat back
support tubes into fabric flap.
H When refitting shoulder straps choose the fabric
holes appropriate to the child's size. Twist the
buckles and feed through seat cover, seat back
and then through holes in plastic seat back arms.
J When refitting seat fabric to seat base pass crotch
strap buckle through the hole in the seat fabric
and then hole in seat base.
K Fasten seat cover restraining strap.
NOTICE: The seat fabric must be wrapped over the
top of the handle tube and fastened by the button
hole. After assembly pull the seat fabric forward and
backward to ensure it will not come off.
11 TO OPERATE THE ADJUSTABLE LEG REST
TO EXTEND THE LEGREST: Feel through seat
corner openings. Locate sliders and pull forward.
Reverse this process to retract legrest.
12 TO REMOVE THE CARRY STRAP
WARNING: NEVER ATTEMPT
TO REMOVE CARRY STRAP
WHEN THE BUGGY IS OCCUPIED.
A Using foot, lift the brake pedal, then press down on the
lever sticking out on the right side of the frame.
B press clip release and remove clip from 'D' ring.
C Slide strap loops from handles.
D Using the foot, push the brake pedal all the way down
until you hear a click.
NOTICE: Make sure both locks are set and look horizontal
to the ground.
The Primary lock is now engaged.
A
C
B
F
E
D
G G
H
K
A
A
C
A
F
E
J
B
D
en
5