Checking/Replacing Battery(Ies) Of Remote Control - Num'axes CANICOM 800 Manual De Instrucciones

Configuration of the "Booster" button:
Programming the Booster button for the dog A or 1 (black collar):
- press « A » or « 1 » button for 5 seconds (level of stimulations flashes on the LCD screen)
- press the « + » or « - » button to modify the level of stimulations
- press the « A » or « 1 » button to confirm the level
Renew the same procedure to program the Booster button for the dog B or the dogs 2, 3 and 4.
O « + » and « - » : control buttons
Use the +/- buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available for CANICOM 800.
18 levels are available for CANICOM 1500.
Level 1: very weak stimulations. Level 15 or 18: strong stimulations.
Always start with the lowest level of stimulation.

Checking/replacing battery(ies) of remote control

O Retro-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off switch
(approx. 1/2 second).
Performance (radio range) of the remote control may deteriorate as battery(ies) become(s) weak.
Be prepared to replace the battery(ies).
CANICOM 800-1500 INDICE CO8:CANICOM 800-1500
To check the condition of the battery(ies), turn "on" the remote control CANICOM 800/CANICOM 1500 and
look at the battery level indicator on the LCD screen. The symbols which appear indicate the following:
Remove the old battery(ies) and replace it (them):
- 1 3-V Lithium CR2 battery for the CANICOM 800 remote control
- 2 LR06 alkaline batteries for the CANICOM 1500 remote control
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your
new purchased product. Other brands of batteries may not operate, or may not be completely
compatible with your product. You can purchase the suitable batteries from NUM'AXES or from
your distributor.
Replace the battery(ies) as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover (ref. Diagram
9 or 10).
All manuals and user guides at all-guides.com
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 800/CANICOM 1500 functions in safety mode and
the system locks up. The battery(ies) must be replaced.
Gb - 27
29/02/08 6:26 Page 27
( (