v « + » and « - » : stimulation level control buttons
Use the "+"/"-" buttons for rapid adjustment of the stimulation level of the receiver collar.
Always start with the lowest level of stimulation.
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be
prepared to replace the battery.
CANICOM 250S_Indice A_CANICOM 200 18/01/2021 11:51 Page21
- Insert the new battery (3-V lithium CR 2430) making
sure the polarity "+" noted on the battery is
visible (ref. Diagram 6).
9 levels are available.
Level 1: very weak stimulation. Level 9: strong stimulation.
Checking/replacing battery of remote control
To check the condition of the battery, turn on the remote control and look at the battery level indicator on
the LCD screen. The symbols which appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 250S functions in safety mode and the system locks up. The
battery must be replaced.
Replace the old battery with a new one as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover.
- Remove the old battery.
- Put the battery cover back in place.
- Retighten the screw.
- Check the remote control operates correctly.
Gb - 21
Diagram 6
« + » of the battery
must be visible