Tommee Tippee closer to nature perfect prep machine Manual De Instrucciones página 8

How to replace the filter
8
Your unit comes with a water filter which lasts approximately 3 months (150 litres of water).
A red change filter warning
light will illuminate when the
filter needs replacing soon
(approx 30 litres remaining).
IF THIS LIGHT FLASHES, THE
FILTER MUST BE CHANGED
IMMEDIATELY.
Descaling
The descaling process will remove deposits of calcium and other minerals in the system that may a ect its performance.
A red decalc / descale warning light will illuminate when the unit requires descaling soon. If the light flashes, you should descale immediately.
Press the cleaning mode
button for 2 seconds to empty
the tank (ensure a suitably
sized container is under the
dispenser to collect the water).
Then press the filter volume
reset button for 2 seconds to
clear the memory.
1. Remove the filter.
2. Fill the water tank with 0.5 litres of distilled white vinegar
(4% or 5%).
3. Place a container under the dispenser outlet.
4. Press the decalc/descale button for 2 seconds and the system
will run a descale process.
During the descale process the red decalc/descale light will
continue to flash.
5. At the end of the descale process an alarm will sound and the
descale LED will switch off.
Remove the old filter from
the hopper and discard.
Replace the hopper
(without the filter).
6. The red cleaning mode light will flash.
YOU WILL NEED TO RUN TWO CLEANING CYCLES.
7. Fill the tank with 1 litre of freshly boiled water.
8. Follow the cleaning cycle steps as per stages 5-15 of the set
up and cleaning process on page 4.
9. Again, fill the tank with 1 litre of freshly boiled water.
10. Repeat the cleaning cycle steps as per stages 5-15 of the set
up and cleaning process on page 4.
11. The current filter can be refitted.
Follow the cleaning cycle
steps as per set up and
cleaning instructions on
page 4 – fitting your new
filter at stage 9a.