Manual regeneration display
1
a) Parking brake display
b) Engine temperature display
c) Driving mode display
d) OK display
e) Particle filter % fill degree display
f) Display of the hours remaining until manual cleaning can be
started
Postponing automatic cleaning
2
Activating manual cleaning
3
Activating automatic cleaning
4
1. Manual regeneration can only be started when all 4 character-
istics are green:
a The parking brake is activated
b The engine temperature has exceeded a particular limit val-
ue
c The machine is in driving mode N (neutral)
d OK then lights up green and the manual burning procedure
can be started
Winter use
Frost protection
1. Ensure there is enough antifreeze in the coolant.
Sweeping system
During winter use, the sweeping system and suction mouth must
be disassembled and placed into storage.
Working with the high-pressure cleaner (ex-factory
Intended use
Use the high-pressure cleaner only for the following activities:
● Cleaning with the high-pressure jet without detergent (e.g.
façades, park seats, garden paths).
● Only operate the high-pressure cleaner with the flat jet nozzle
provided.
● This high-pressure cleaner is intended and tested for the ex-
clusive use with the sweeper vacuum MC 130.
Pressure relief valve
When the water quantity is reduced via the pressure/quantity
control on the trigger gun, the overflow valve opens and part of
the water flows back to the suction side of the pump.
Safety valve
The safety valve opens when the permissible operating pressure
is exceeded and the water flows back to the suction side of the
pump.
option)
Trigger gun
1
Pressure and quantity regulation
2
Spray lance
3
High-pressure hose connection
4
Nozzle holder
5
High-pressure hose storage compartment
6
High-pressure hose
7
Fastening high-pressure hose
8
Fastening trigger gun
9
Fastening trigger gun
10
Trigger gun lever
11
Water inlet from water reservoir
1
Stop cock
2
High-pressure cleaner hydraulic connection
3
Water inlet for high-pressure pump
4
English
Device elements
81