Additional Security; Slide Extension; Timer Cams - Alliance Laundry Systems 505048R2 Manual De Instalación Y Operación

Torx security screws are available (as optional equipment
at extra cost) for securing lower access panel to dryer
base. Order part number 62853.
A Torx bit, part number 282P4, is available (as optional
equipment at extra cost) for installing the Torx security
screws.
Remove slide extension, screws and lockwashers from
the accesssories bag and install the extension on the top
of the coin slide.
IMPORTANT: Slide extension must be attached to
top side of the coin slide to make it long enough to
activate the accumulator.
The dryer timers are factory equipped with a 45 minute
timing cam. If this drying time is not suitable to your
installation, the following cams can be found in the
accessories bag.
ELECTRIC DRYERS
1-53242 Cam (30 Minutes)
1-53240 Cam (60 Minutes)
6

Additional Security . . .

Slide Extension . . .

(Coin Slide Models Only)

Timer Cams . . .

(Coin Slide Models Only)
A Torx bit holder, part number 24161, is available (as
optional equipment at extra cost) to be used with the Torx
bit.
NOTE: This dryer, as shipped from the factory, does
not include the coin slide, coin drawer, lock or keys.
This coin slide kit (or parts) must be ordered, at extra
cost, according to the purchaser's requirements
direct from the coin kit manufacturer of your choice.
GAS DRYERS
1-53242 Cam (30 Minutes)
A 60 minute timing cam, Part No. 53240, is available for
the gas dryer as optional equipment at extra cost.
505048