Powering With The Ac Adapter; Installing The Imager Head Cable Or Extension Cables; Installing Accessories; Installing Sd™ Card - RIDGID Micro CA-300 Manual Del Usuario

micro CA-300 Inspection Camera
Figure 6 - Removing/Installing Battery
2. Insert contact end of battery into the in-
spection tool, as shown in Figure 6.
3. Replace battery compartment cover.

Powering with the AC Adapter

The micro CA-300 Inspection Camera can al-
so be powered using the supplied AC Adapt-
er.
1. Open the right side port cover (Figure 3).
2. With dry hands, plug the AC adapter into
the outlet.
3. Insert the AC adapter barrel plug into the
port marked "DC 5V".
Figure 7 - Powering the Unit with AC
Adapter
Installing the Imager Head Cable
or Extension Cables
To use the micro CA-300 Inspection Cam er a,
the imager head cable must be connected to
the handheld display unit. To connect the ca-
ble to the handheld display unit, make sure
the camera socket key and display unit sock-
et slot (Figure 8) are properly aligned. Once
8
they are aligned, finger tighten the knurled
knob to hold the connection in place.
Figure 8 - Cable Connections
3' (90 cm) and 6' (180 cm) cable extensions
are available to increase the length of your
camera cable up to 30 feet (9 meters). To in-
stall an extension, first remove the camera
head cable from the display unit by loosen-
ing the knurled knob. Connect the extension
to the handheld as described above (Figure
8). Connect the keyed end of the camera
head cable to the slotted end of the exten-
sion and finger tighten the knurled knob to
hold the connection in place.

Installing Accessories

The three included accessories, (Hook, Mag-
net, Mirror) all attach to the imager head the
same way.
To connect, hold the imager head as shown in
Figure 9. Slip the semicircle end of the acces-
sory over the flats of the imager head. Then
rotate the accessory a 1/4 turn to retain.
Figure 9 - Installing an Accessory
Installing SD™ Card
Open the left side port cover (Figure 4) to ac-
cess the SD card slot. Insert the SD card into
the slot making sure the contacts are facing
towards you and the angled portion of the
card is facing down (Figure 10) . SD cards can
only be installed one way – do not force.
When an SD card is installed, a small SD card
icon will appear in the bottom right hand
portion of the screen, along with the num-
ber of images or length of video that can be
stored on the SD card.
Accessory