Stryker 8203-026-000 Manual Del Usuario página 3

8203-026-700 Rev-AA
▪ Upon initial receipt and before each use, clean
and sterilize the equipment as indicated. See
the care instructions manual supplied with the
handpiece.
▪ Upon initial receipt and before each use, operate
the equipment and inspect each component for
damage. DO NOT use any equipment if damage
is apparent. See the care instructions manual
supplied with the handpiece.
▪ ALWAYS slide the function switch to the safe
mode position when the handpiece is idle, before
installing an attachment or accessory, or when
passing the handpiece to another person.
▪ DO NOT attempt to install or remove an
attachment or accessory while the handpiece is
operating.
▪ Before operating the handpiece, ALWAYS gently
tug the attachment and accessory to make
sure the attachment is securely locked in the
handpiece and the accessory is securely locked
in the attachment.
▪ ALWAYS operate the equipment within the
specified environmental condition values. See the
instructions for use supplied with the handpiece.
▪ ALWAYS follow the recommended duty cycle to
prevent the equipment from overheating. See the
instructions for use supplied with the handpiece.
▪ DO NOT grasp or touch any rotating component
while the handpiece is operating.
www.stryker.com
▪ Use only Stryker-approved equipment, unless
otherwise specified.
▪ DO NOT modify any equipment without the
authorization of the manufacturer.
▪ DO NOT reuse, reprocess, or repackage a device
that is intended for single use only.
- A single use device may not withstand
chemical, chemical vapor, or high temperature
sterilization reprocessing.
- Design features may make cleaning difficult.
- Reuse may create a contamination risk and
compromise structural integrity resulting in
operational failure.
- Critical product information may be lost during
repackaging.
Failure to comply may lead to infection or cross
infection and result in patient and/or healthcare
staff injury.
▪ DO NOT disassemble or service this equipment
without the authorization of the manufacturer.
CAUTION: ALWAYS store the equipment within the
specified environmental condition values throughout its
useful life. See the instructions for use supplied with
the handpiece.
NOTE: When used with handpieces, the attachments
described in this manual are applied parts. For more
information, see the instructions for use supplied with
the handpiece.
EN
3