To Mount & Remove The Xtender Wheels; G.STorage Tips; H.CHeck Out - Quickie XTENDER Manual De Instrucciones

ENGLISH
F. MOUNT AND REMOVE THE XTENDER WHEELS
The rear wheel axle (B) attaches the rear wheel thru to the axle sleeve (C). When the detent balls (D) engage
into the axle sleeve, the rear wheel effectively becomes locked onto the chair. Pulling up on the quick-release
handle (A) disengages the detent balls and allows mounting, or removal of the axle and wheel assembly.
Do not use this chair UNLESS you are sure both quick-release axles are locked and the guide pins are in the
correct location. An unlocked axle/wheel may come off during use and cause a fall. The detent ball (D) must
feed all the way thru the axle sleeve for the axle and wheel to lock. Be sure to check for a positive lock by try-
ing to pull the axle and wheel out of the camber plug/axle sleeve. If the axle does not positively engage make
sure to have your dealer adjust it.
NOTE - Setup for this step should include putting the wheelchair on a workbench or table to make the process
easier.
1. Install the Xtender wheel
a. Lift the quick-release handle (A) fully.
b. Insert axle (B) through axle sleeve (C).
c. Line up the appropriate guide pin with the corresponding receiver hole on the Axle plate
assembly.
d. Keep handle (A) lifted as you slide axle (B) into axle sleeve (C).
e. Push the handle back to home position to lock axle onto the chair.
f. Repeat these steps for the other side of your wheelchair.
2. Power cord installation
a. Locate the Power/Battery cord (G) (Battery backpack).
b. Insert and twist the plug end of the cord into the power receiver (F).
c. Check to make sure the Plug and receiver are locked in place before travel.
d. The Xtender should be ready for use.
3. To Remove the Xtender Wheel
a. Remove and store the battery anytime the unit is being moved or stored.
b. Lift the quick-release handle (A) fully.
c. Remove wheel by sliding axle (B) out of axle sleeve (C).
d. Repeat steps on the other side of your wheelchair.
G. STORAGE TIPS
1. ALWAYS remove the battery and replace the protective battery cover when storing or mov-
ing the unit. Optimal storage temperature is between 50°F and 77°F.
2. Store your unit in a clean, dry area. If you fail to do so, parts may rust or corrode.
3. Before using your unit, make sure it is in proper working order.
4. Inspect and service all items on the "Maintenance Chart".
5. If stored for more than three months, have your unit inspected by an authorized dealer
before use.
6. When not in use the battery shoud be recharged every three months to ensure optimum
performance after being stored.
H. CHECK-OUT
After the installation of the Quickie Xtender, and the wheelchair is assembled and adjusted, it should roll
smoothly and easily. All accessories should also perform smoothly. If you have any problems, follow these pro-
cedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly
prepared.
2. Review the troubleshooting chart at the beginning of this section.
3. If your problem persists, contact your authorized dealer. If you still have a problem after contacting your
authorized dealer, contact Sunrise customer service. See the Introduction Page for details on how to con-
tact your authorized dealer or Sunrise customer service.
MK-100156 Rev. B
WARNING
4
1 2 3
12
1
A
2
A
D
3
4
G
F