GE IM-4 Manual Del Usuario página 10

ICEMAKER INSTALLATION INSTRUCTIONS C
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
• Remove the screw (A) that holds the electrical
plug cover in place. You will not need this screw
and cover.
• Remove the light shield insert (B) and discard it.
• Loosen the two mounting screws (C)
approximately 1/2" (13 mm). DO NOT REMOVE
THESE SCREWS.
C
All manuals and user guides at all-guides.com
Installation Instructions
C F
Unplug the
Pliers Sharp knife
B
A
Cover
removed
G H J K L M N
2 INSTALL FILL TUBE
Cut the fill tube extension (10) to the length
(refer to the template on page 63) with a
C
sharp knife or single-edge razor blade and slide
it onto the fill tube against the stop.
10
C
3 SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the power
switch in the OFF position until the refrigerator is
connected to the water supply to prevent premature
operation.
Power
Switch
4
POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List on
page 7. Plug the female end of the power cord adapter
(21) onto the male terminals on the icemaker power
cord. When connecting the adapter to the power cord,
make sure the seal is in place between the connectors.
Secure the power cord adapter to the icemaker by
putting it into the hook at the back of the icemaker
and attaching it to the icemaker with a wire tie (24).
Hook
10
or R
P Q
C
Hole for
wire tie
Seal
Wire tie
Hook