GE IM-4 Manual Del Usuario página 42

ICEMAKER INSTALLATION INSTRUCTIONS N
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE ICE CUBE TRAY SHELF
1
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• There are two white plug buttons above the screw
holes. Remove these plug buttons and install
them in the two screw holes that were used to hold
the ice cube tray shelf.
• Install two Phillips head screws (14) in the holes
that the plug buttons were in, but do not screw
them all the way in. The screw heads should extend
about 1/2" (13 mm) from the side wall of the
freezer.
Plug
Buttons
All manuals and user guides at all-guides.com
Installation Instructions
C
Unplug the
Pliers Sharp knife
14
F G H J K L M
PREPARE FOR INSTALLATION
2
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
• Remove the outlet cover with a flat-blade
screwdriver.
INSTALL FILL TUBE
3
• Cut the fill tube (16) to the
length (refer to the
on page 62) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Go to the back of the
refrigerator. On the tube side
of the water tube inlet (15)
there is an adhesive backing.
Remove the adhesive backing
and slide the tube into the hole near the top at the
back of the refrigerator. Firmly press on the inlet to
secure it to the refrigerator.
4 SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
42
or R
N P Q
N
template
N
15
Hole for
wire tie
16