Tools You Will Need - GE IM-4 Manual Del Usuario

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS C
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.

TOOLS YOU WILL NEED

Flat blade and Phillips
screwdrivers
5/16" Nutdriver
REMOVE THE COVER
1
At the bottom rear of the refrigerator, remove the
screw(s) holding the compressor compartment
cover (if covered) and save for reinstallation later.
Bend the cover back for access to the compartment.
All manuals and user guides at all-guides.com
Installation Instructions
C F
Unplug the
Sharp knife
Pliers
G H J K L M N
ATTACH THE WATER VALVE
2
• Locate the female connector plug (A) which is
attached to the cabinet with a wire tie. Remove
the wire tie and discard it.
• Remove and discard the tape from the female
connector (A) and plug onto the male terminals
on the water valve (4). Either wire can go on
either terminal.
• Fasten the water valve to the cabinet edge hole
using the hex-head screw (13) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
• Check the plastic water line nut on the bottom of
the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
12
or R
P Q
Wire tie
A
A
4
13