GE IM-4 Manual Del Usuario página 54

ICEMAKER INSTALLATION INSTRUCTIONS R
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PARTS REQUIRED THAT CAME
WITH THE REFRIGERATOR
Ice bucket
PREPARE FOR INSTALLATION
1
• Remove all freezer baskets for greater accessibility
to the rear of the freezer.
• Remove and discard the
large white plug from
the rear freezer wall.
Pull out the gray
insulation plug and
remove any debris.
• Remove the outlet cover
with a flat-blade screwdriver.
All manuals and user guides at all-guides.com
Installation Instructions
C F
Unplug the
Sharp knife
Pliers
Icemaker mounting block
G H J K L M N
2 INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
on page 62) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Go to the back of the refrigerator.
Remove the label covering the
hole. Pull out the insulation plug
and any debris.
• On the tube side of the water tube
inlet (15) there is an adhesive
backing. Remove the adhesive
backing and slide the tube into the
hole near the top at the back of the refrigerator.
Firmly press on the inlet to secure it to the
refrigerator.
3
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
4
INSTALL THE MOUNTING BLOCK
• Inside the freezer, remove the two small white plug
buttons from the side wall.
• Using the Phillips head screws
that are with the mounting
block, attach the mounting
block to the refrigerator by
driving the screws through the
outer holes on the block and
into the holes that the plug
buttons were in.
• Install two Phillips head screws
(14) from the kit in the inner holes on the mounting
block. The screw heads should extend about 1/2"
(13 mm) from the mounting block.
54
or R
P Q
R
template
R
15
Hole for
wire tie
16