5
POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List on
page 7. Plug the female end of the power cord adapter
(22) onto the male terminals on the icemaker power
cord. When connecting the adapter to the power cord,
make sure the seal is in place between the connectors.
Secure the power cord adapter to the icemaker by
putting it into the hook at the back of the icemaker
and attaching it to the icemaker with a wire tie (24).
22
Hook
6
INSTALL THE ICEMAKER FILL
CUP AND INSERT
Install the icemaker fill cup (side-mounted)(18) into
the icemaker as shown.
7
PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the power
cord plug into the socket, making sure that the
prongs and holes are matched. Press the plug firmly
into the socket. Lock the plug in place by clipping the
restraints onto each side of the plug. Make sure the
restraints click into place.
All manuals and user guides at all-guides.com
Installation Instructions
Seal
Wire tie
Hook
18
35
MOUNT THE ICEMAKER
8
• Lift the icemaker so the fill tube extension (10) fits
in the fill cup opening (C). Hang the icemaker on
the two mounting screws (A).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube extension (10) is still in the fill cup
opening. (Check the rear of the refrigerator to
make sure the fill tube has not been pushed out of
the back of the refrigerator.)
• The icemaker mounting screws are located in the
uppermost position of the mounting slots.
THEN TIGHTEN THE ICEMAKER MOUNTING
SCREWS SECURELY.
9
INSTALL THE ICE BUCKET
Place the ice bucket
that came with your
refrigerator in place under
the icemaker.
Make sure the icemaker
power switch is set to OFF .
10
ATTACH WARRANTY LABEL
A label (9) is provided with this kit to record the date
of installation for warranty purposes. Apply it to the
back of the refrigerator.
11
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
10
A
C