Fanaway Mya Installation Instructions
INSTALL THE FAN ASSEMBLY TO THE MOUNTING BRACKET
Install the fan assembly to the mounting bracket (Fig.8a):
•
Loosen two canopy screws (1) and remove from the mounting bracket.
•
Loosen two canopy screws with star washer (2) by half thread from the mounting bracket. (For
L-shape slot on canopy to be mounted).
•
Lift the hanging canopy (3) of the fan assembly up to the mounting bracket and let the L-shape slot
on the hanging canopy (3) go through the two canopy screws with star washer (2). (Fig.8b)
•
Turn the hanging canopy (3) until it locks in place at the end section of the L-shape slot, ensure the
star washer are between the hanging canopy (3) and screw head. Secure it by tightening the two
canopy screws with star washer (2).
•
Secure and tighten the canopy screws (1) to the mounting bracket. The hanging canopy (3) shall
have 4 screws (1) & (2) in total. Avoid damaging the electrical wiring prepared previously when
hanging the canopy.
Fig. 8b
7 | P a g e
1
2
3 - hanging canopy
Fig. 8a
1
M Y A - M E N A R D S V e r s i o n 1 . 0 1 / 2 0 2 1
2 – screw with star washer