Warranty Statement - Worx WG103 Manual Del Usuario

When the required amount of line is fed out,
gently pull on the second line (there is no need
to press the manual line feed button again). If
the line extends past the line cutter, too much
line has been fed out.
If too much line is fed out, remove the spool
cap and click the spool anti-clockwise until the
line is at the desired length.
REMOVING THE CAP
Press and hold in the two latches (12) (See J).
Pull cap away from the spool holder. Keep the
cap and spool holder clean from debris. To re-
place the cap, press it firmly towards the spool
holder. Ensure that it is correctly connected by
trying to remove it without depressing the two
latches.
CHANGING THE LINE SPOOL:
First take off the cap and remove the old spool.
Place the new spool into the cap and make
sure the spool is in line with the trimmer's
eyelets. Feed one line through the eyelet, then
repeat for second line. Reattach the cap
Warning! Your Trimmer is designed to
only use line with a maximum diam-
eter of 0.065". Only use nylon line.
IMPORTANT - Always wind the line onto
the upper section of the spool first.
TO MANUALLY WIND LINE
Take approximately 16ft line and insert 5/8" of
line into one of the holes in the upper section of
the spool. Wind the line in the direction of the
arrows on the top of the spool.
Leave approximately 4" of line unwound and
place it into the cleat. Repeat on the lower sec-
tion of spool.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit the spool as described above in
"Changing the Line Spool".
MAINTENANCE
After use, disconnect the machine from the
power supply and check for damage. Your
power tool requires no additional lubrication
or maintenance. There are no user serviceable
parts in your power tool. Electric trimmers
Grass Trimmer
CTC-WG103-M-060418.indd 9
should only be repaired by an authorised re-
pairer. Use only manufacturers recommended
replacement parts and accessories.
Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place out
of the reach of children. Keep the motor ven-
tilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in
the ventilation slots, this is normal and will not
damage your power tool.

WARRANTY STATEMENT

30 DAY Satisfaction Guarantee
If for any reason you are dissatisfied with any
WORX product, you can return the product
along with proof of purchase within 30 days for
a full refund.
If your WORX product becomes defective due
to faulty materials or workmanship within the
specified warranty period of;
• 24 months for DIY and light trade use, from
the date of purchase.
We guarantee to repair or replace all defective
parts free of charge, repair products subject
to fair wear and tear, free of charge, or at our
discretion, replace the unit free of charge
to ensure minimum inconvenience to the
customer. Your warranty is subject to the
following conditions:
• Proof of purchase date and a valid receipt is
produced.
•The product has not been misused.
•The product has not been used for Professional
purposes.
• Unauthorized persons have not attempted
repairs.
• The product has not been used for hire
purposes.
•The product has not sustained damage through
foreign objects, substances or accidents.
• Damage is not a result of fitting non-approved
accessories.
To claim the guarantee, you will need to submit
09
ENG
2006-4-20 14:28:36