Information To User - Kyocera ST-30 Guia De Instalacion

WARNING:
FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer for
compliance could void the user's authority to operate the equipment.

Information to user:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
❐ Reorient or relocate the receiving antenna.
❐ Increase the separation between equipment and receiver.
❐ Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
❐ Consult the dealer or an experienced radio/TV technician for help.
Changes od modifications not expressly approved by the manufacture for compliance could void the user's authority to operate the equipment.
Warning: Move with care
The bulk stacker/other units/printer combination should not be moved by children without proper guidance from an adult.
Push to move the stacker, do not pull or guide from front. Quick stops, excessive force, or uneven surfaces may cause the stacker to tip while
being moved.
Note on Power
The socket-outlet shall be installed near the equipment and shall be easily accessible.
10
ST-30.p65 10 01/6/18, 10:02 AM