Improper Use Of Appliance; Start-Up; Cleaning Internal Parts; Main Causes Of Operating Failure - NTF SLF320 Instrucciones Y Advertencias

make sure that you fully uncoil the power supply cable and check that it is not crushed in any way
•
if the power supply cable is damaged, it must be replaced by qualified, authorized personnel using
•
the special cable available from one of the Authorized Service Centers

5.5 IMPROPER USE OF APPLIANCE

This appliance is designed to make ice from cold drinking water. Any other use shall be deemed
improper. In particular:
• do not use the ice bin to cool or store food or drinks, because these operations could contaminate the
ice contained in it or obstruct the drainage outlet, causing the bin to fill with water and overflow.
• do not remove ice from the container with the hands or equipment other than that supplied with the
appliance, which must be stored in a suitable place to prevent contamination and be cleaned and
sanitized daily
• do not obstruct the ventilation and heat-dissipation grilles, since poor aeration - in addition to reducing
efficiency and causing poor operation - may also cause serious damage to the appliance
• do not rest objects on the appliance or in front of the ventilation grilles
• open and close the door carefully without slamming it
• do not remove any of the panels or grilles

6.1 CLEANING INTERNAL PARTS

The appliance will have already been cleaned in the factory. However, you are advised to wash the
internal parts again before using the appliance.
Make sure that the power supply cable is unplugged before carrying out the above cleaning operation.
For information about cleaning and sanitizing operations, see chapter 9.3 of this manual.
It is advisable to avoid using abrasive detergents or powders, since these might damage the finish.

6.2 START-UP

Once the appliance has been correctly connected to the electricity mains, water mains and water drain
system, it can be started up as follows:
a) turn on the water supply tap (8 in Fig. 5)
b) insert the plug in the socket and switch on the power supply by means of the relative switch fitted
during the installation phase (7 in Fig. 5)
Switch on appliance by pressing the luminous switch (13 in Fig. 3).
If the appliance fails to produce ice, before contacting the Authorized Service Center check that:
• the water supply tap (8 in Fig. 5), fitted during the installation phase, has been turned on
• electric power is reaching the appliance; the plug is properly inserted in the socket, the switch
(7 in Fig. 5) is in the "ON" position, and the push button (13 in Fig. 3) is lighted up
Furthermore:
• if there is excessive noise, make sure that the appliance is not touching furniture or sheet metal which
can give rise to noise or vibrations
• should any trace of water appear, check the drain hole of the container to ensure that it is not clogged,
that the water fill and drain pipes are correctly connected and are not throttled or damaged
• make sure that the temperature of the air or water does not exceed the installation limit values
(see paragraph 5.2)
• make sure that the water inlet filter is not clogged (see paragraph 9.1)
If the fault still persists after the above checks have been made, switch off the appliance with the switch
fitted during the installation stage, unplug the appliance, turn off the water supply tap and contact one of
the Authorized Service Centers.
6 START-UP

7 MAIN CAUSES OF OPERATING FAILURE

E
E
n
n
g
g
l
l
i
i
s
s
h
h