Advice About Transportation; Unpacking; Installation; Connection Diagram - NTF SLF320 Instrucciones Y Advertencias

The weighted equivalent continuous sound level A of this appliance is less than 70 dB (A). The
measurements were made during ice production, at a distance of 1 m from the surface of the appliance
and at a height of 1.60 m from the floor.
During normal operation the appliance does not generate vibrations which can cause actual or potential
danger situations.
The wiring diagram is stuck on the front counterpanel of the appliance or in the internal part of front
panel.
In order to gain access thereto, unplug the appliance from the power source, loosen screws holding the
front panel, and slide it away after first opening the door (Fig. 4).
The net weight and the weight including packaging of the appliance are given on the cover of this
Instruction Manual. Please refer to the instructions on the packaging in order to correctly transport and
lift the appliance.
To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that
the appliance is kept upright during transport, storage, and handling. Follow the instructions given on
the packaging.
The appliance must be installed by authorized personnel, in compliance with the local laws in
force and the Manufacturer's instructions.
Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT
THE APPLIANCE IS IN A PERFECTLY GOOD CONDITION. IF IN DOUBT DO NOT USE IT AND
IMMEDIATELY CONTACT THE DEALER who sold it to you.
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed
and put out of the reach of children, as they are potential sources of danger.
Rest the wooden pallet on the floor and, using a hex socket wrench, loosen and remove the bolts
(Fig. 2) that fix the appliance to the pallet.
Lift the appliance using equipment fit to bear its weight. Separate the appliance from the wooden pallet
and fit the supplied legs into the housings on the base plate provided for the purpose (6 in Fig. 3).
Use a spirit level to ensure that the appliance is standing perfectly level. If necessary, adjust the legs.
It is the user's responsibility to provide everything necessary for the correct installation of the appliance,
in particular:
• preparation of an installation area which is sufficiently ventilated and accessible for maintenance
operations
• connection to the mains power supply, mains water supply and sewage network, including any
masonry work or pipes which may be required, in compliance with local regulations
• the appliance must be installed with adequate backflow protection to comply with applicable
federal, state and local codes
5.1 CONNECTION DIAGRAM (Fig. 5)
7. electrical connection controlled by omnipolar circuit-breaker with residual current device
8. water tap
9. water supply pipe
10. water drainage pipe

3 ADVICE ABOUT TRANSPORTATION

4 UNPACKING

5 INSTALLATION

E
E
n
n
g
g
l
l
i
i
s
s
h
h