Assembly / Setup; Assembly & Set-Up; Holder Instructions; Operation - Derungs D MED OPTICLUX Hand 10-1 DL Manual De Usuario

ENG
3.

ASSEMBLY / SETUP

3.1

Holder instructions

►
The supplied packaging is folded into a holder.
►
1. Fold the packaging once in the middle
►
2. Detach the strap from the bottom and fold it upward.
Insert the fastening screw (included) into the tab's hole
►
and tighten it.
►
If the hand magnifying lamp is placed in the holder, it
must always be protected in the felt case.
16
1.
2.
4.

OPERATION

4.1

Hazard warnings

DANGER
Death hazard from electric shock
►
The device must not be operated or used if it shows
defects that may endanger patients, operating
personnel or third parties. Visually inspect and
function test before using.
►
Use only an original charger or one tested according
to EN 60601-1 or EN 60950.
►
If the power cable shows damage, immediately
replace it with a new one.
►
The connection voltage and frequency must match
the data on the type plate.
WARNING
Eye injury warning
►
This product may emit dangerous radiation. Never
look directly into the light cone.
►
The radiation emitted by this product conforms to the
exposure limit value for reducing the risk of
photobiological hazards based on IEC 62471.
4.2

First operation

When delivered, the luminaire is in a battery-saving transport
mode.
1.
2.
To deactivate the transport mode, the luminaire must be
completely charged once before first use.
3.
4.
CAUTION
►
During the charging process, the hand magnifying
lamp is in battery-saving status and cannot be turned
on.