Maintenance & Safety; Periodic Inspections - Verathon GlideScope Go Instalación Y Manual De Funcionamiento Y Mantenimiento

All manuals and user guides at all-guides.com
MAINTENANCE & SAFETY
WARNING
cause serious injury to the operator or damage to the instrument and will void the warranty.
Contact Verathon
®
WARNING

PERIODIC INSPECTIONS

In addition to the user performing routine inspections before and after every use, periodic
inspections should be performed to ensure safe and effective operation. It is recommended
that you perform a full visual inspection of all components at least every three months. The
inspector should check the system for the following:
• External damage to the equipment
• Damage to the power adapter
• Damage to the connectors
Report any suspected defects to Verathon Customer Care or your local representative.
BATTERY
After 300 charge and discharge cycles, the battery capacity is approximately 80% of the
initial capacity. Under normal operating conditions, this may happen at around 3 years. For
more information about the battery, see
The battery is not user‑replaceable. Do not attempt to replace the battery. Any attempts to
replace the battery by unauthorized service technicians may cause serious harm to the user
and will void the warranty. For more information, contact Verathon Customer Care or your
local representative.
SYSTEM SOFTWARE
This manual documents the most current version of the software. If your monitor does not
function as described in this manual, or to determine if your software should be updated,
contact Verathon Customer Care. Do not perform any software upgrades from third‑party
vendors or attempt to modify the existing software. Doing so may damage the monitor
and void the warranty.
Do not attempt to open the system components. This may
Customer Care for all servicing needs.
No modification of this equipment is allowed.
Battery Specifications on page 21.
19