Service Information - Stanley FatMax FMFP70979 Manual De Instrucciones

1. Ensure On/Off switch is in the OFF position.
2. Allow the unit to cool.
3. Remove air compressor plug from outlet.
4. Drain air tank.
5. Locate a suitable container under pump drain plug (L).
6. Remove the dipstick (K) from crank case.
7. Remove the oil drain plug (L).
8. Allow ample time for all oil to drain out. (Tilting the compressor
towards the drain plug will assist in draining.)
9. Install the oil drain plug.
10. Fill pump with air compressor oil, SAE 40.
11. Replace dipstick.
Lubrication and Oil
NOTICE: The compressor was shipped without oil in the crankcase.
A small amount of oil may be present in the pump upon receipt of the
air compressor. This is due to testing and does not mean the pump
contains oil. Do not attempt to operate this air compressor without
first adding oil to the crankcase. Serious damage can result from even
limited operation unless filled with oil and broken in correctly. Closely
follow Initial Set-up under Operation.
NOTICE: Multi-viscosity motor oils, like 10W-30, should not be
used in an air compressor. They leave carbon deposits on critical
components, thus reducing performance and compressor life. Use
air compressor oil only, SAE 40.
1. Place unit on a level surface.
2. Remove dipstick (K) and slowly add air
compressor oil (supplied). NOTE: See
Specifications for pump oil capacity.
NOTICE: Overfilling with oil will cause premature
compressor failure. Do not overfill.
3. Replace dipstick.
All manuals and user guides at all-guides.com
ACCESSORIES
Recommended accessories for use with your tool are available
for purchase from your local dealer or authorized service center. If
you need assistance in locating any accessory for your tool, please
contact Stanley Tools, 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-262-2161 or visit our website www.stanleytools.com
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous. Use only accessories rated
equal to or higher than the rating of the air compressor.

SERVICE INFORMATION

Please have the following information available for all service calls:
Model Number ____________ Serial Number _________________
Date and Place of Purchase ______________________________
K
16