Citizen CT-E601 Manual De Usuario página 86

6. Press the FEED button.
A setting is printed each time the FEED button is pressed in order through the cycle.
When the current settings are printed, the COVER LED lights.
Press the FEED button until the setting you want is printed.
7. Press the FEED button for at least two seconds.
The selected settings are set.
The next memory switch function and settings are printed.
8. Repeat steps 5 to 7 to change different functions for the current memory switch num-
ber.
9. Open the paper cover and close it.
The changed memory switch settings are printed.
10. Repeat steps 4 to 9 to change functions for a different memory switch number.
11. Press the FEED button until "Save To Memory" is printed.
12. Press the FEED button for at least two seconds.
The changed memory switch settings are saved and a list of them is printed.
The printer exits individual setting mode when printing is finished.
Memory switch initialization
Set all the memory switches to the factory settings.
1. Do steps 1 through 3 of the procedure to enter individual setting mode.
2. Press the FEED button until "Save To Memory" is printed.
3. Open the paper cover.
4. Press the FEED button for at least two seconds.
All memory switches change to the factory settings.
5. Close the paper cover.
The function of each memory switch is shown in the following table. (Shaded values are
factory settings.)
Switch no.
MSW1-1
MSW1-2
MSW1-3
MSW1-4
MSW1-5
Function
Power ON Info
Buffer Size
Busy Condition
Receive Error
CR Mode
– 86 –
OFF
Valid
4K bytes
Full/Err
Print"?"
Ignored
ON
Not Send
45 bytes
Full
No Print
LF