Bluetooth® Connection - Renault Radio Connect R & GO Manual Del Usuario

PAIRING AND UNPAIRING A TELEPHONE
Bluetooth® connection
Make sure the Bluetooth® connection
of your hands-free system is activated.
Please refer to the information on the
"Bluetooth® function" in the "General
description" section.
Pairing a phone
In order to use your hands-free phone
system, you must pair your Bluetooth®
mobile to the vehicle before using it for
the first time.
Pairing will enable the hands-free
phone system to recognise and store a
phone.
You can pair up to five phones, but only
one can be connected at a time to the
hands-free phone system.
Pairing is carried out on the system and
on your phone. Your audio system and
phone must both be switched on.
Note: if a phone is already connected,
during a new pairing procedure, the ex-
isting connection will automatically be
disconnected.
GB.18
All manuals and user guides at all-guides.com
(1/2)
Scan devices
Pair device
Sel. Device
Two ways of pairing your phone are
available:
– "Scan devices";
– "Pair device"
"Scan devices"
This method allows you to search for
your phone from your car radio system.
To pair a phone using "Scan devices",
perform the following steps:
– Display the telephone menu by
pressing 7;
– select "Scan devices" by turning and
pressing 6.
Searching for Bluetooth® devices
present in the vicinity starts (this search
can take up to sixty seconds.) The mes-
sage "Searching..." appears on the sys-
tem's screen.
– Follow the steps shown on the
system screen.
– the message "Phone connected" ap-
pears on the screen;
The device is automatically saved and
connected to the vehicle.
After sixty seconds, if pairing fails,
repeat these steps.
For more information, refer to your
phone's user manual.
– The message "Phone connected"
appears on the screen.
The device is automatically saved and
connected to the vehicle.
After sixty seconds, if pairing fails,
repeat these steps.
For more information, refer to your
phone's user manual.
For safety reasons, carry
out these operations when
the vehicle is stationary.