Simer 3985C Manual Del Usuario página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
Piping
Piping must not be smaller than pump discharge.
Electrical
Hazardous voltage. Can shock, burn, or kill.
When installing, operating, or servicing this pump, follow the
safety instructions listed below.
Do not lift pump by the power cord.
1.
DO NOT splice the electrical power cord.
2.
DO NOT allow the electrical cord plug to be submerged.
3.
DO NOT use extension cords. They are a fire hazard and
can reduce voltage to prevent pumping and/or damage
motor.
4.
DO NOT handle or service the pump while it is connected
to the power supply.
5.
DO NOT remove the grounding prong from the plug or
modify the plug. To protect against electrical shock, the
power cord is a three-wire conductor and includes a
3-prong grounded plug. Plug the pump into a 3-wire,
grounded, grounding-type receptacle. Connect the pump
according to the NEC or CEC and local codes.
PUMP, MOTOR, SWITCH, & CORD SPECIFICATIONS
Motor
Motor Full
Branch Circuit
HP
Load Amps
Required (Amps)
1/2
9.5
WARNING
Risk of electrical shock.
Can burn or kill.
Do not lift pump by
power cord.
For parts or assistance, call Simer Customer Service at
Individual
Cord Length
in ft. (mm)
15
8 (203)
CORD LIFT WARNING
The pump is plugged into a vertical switch for automatic
operation. The pump will run continuously when plugged
directly into an electrical outlet.
Connect or wire pump to its own individual branch circuit with
no other outlets or equipment in the circuit. Size fuses or
circuit breakers according to the "Pump, Motor, Switch and
Cord Specifications" chart.
Risk of electrical shock and fire. Be sure
that power supply information (Voltage/Hertz/Phase) in
this manual matches incoming power supply exactly.
Install pump according to all electrical codes that apply.
NOTICE: Proper ventilation is needed to prevent negative
basin pressure and to provide air within the basin.
The basin should be located at the lowest place in the
basement or area to be drained. Floor drains from other areas
in the basement may be tiled into the basin. Drain tile around
a house foundation may also be tiled into the basin, effectively
removing water and relieving pressure from this area.
Basin covers are used to exclude refuse from the basin.
Switch Setting in inches (mm)
On
Off
8 (203)
4 (102)
1.
Attempting to lift or support pump by power
cord can damage cord and cord connections.
2.
Cord may pull apart, exposing bare wires with
possibility of fire or electrical shock.
3.
Lifting or supporting pump by power cord will
Lift by
void warranty.
handle
4.
Use handles on top of pump for all lifting/
lowering of pump. Disconnect power to pump
before doing any work on pump or attempting
to remove pump from sump.
5597 0407
1-800-468-7867 / 1-800-546-7867
2
Discharge
Adapter
Size
1-1/2"

Publicidad

Tabla de contenido
loading

Tabla de contenido