Attaching The Fan Blades - HAMPTON BAY 186 977 Manual Del Propietário

Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWN-
ROD MOUNTING, THE TAB IN THE RING AT
THE BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling canopy
with the two screws in the mounting plate.
Push up to engage the slots and turn clock-
wise to lock in place. Immediately tighten
the two mounting screws firmly.
2. Install the remaining
screws into the holes in the canopy and
tighten firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws
in the canopy. Rotate the ring counter-
clockwise to lock in place.
4. You may now proceed to attaching the
fan blades.
8.
All manuals and user guides at all-guides.com
CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mount-
ing plate and align the locking slots of the
ceiling canopy with the two screws in the
mounting plate. Push up to engage the slots
and turn clockwise to lock in place. Imme-
diately tighten the two mounting screws
firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE
ENGAGED AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
two mounting
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the fan
blades.
Attaching the
Fan Blades
1. Attach the blade to blade bracket using the
screws as shown in figure 14. Please note
that the rubber washers are pre-attached
to the blade bracket. Start a screw into
the bracket. Repeat for the two remaining
screws.
2. Tighten each screw securely.
Screws
Rubber Washers
Blade Bracket
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot on
the bottom of the motor and tightening the
blade bracket screws. Please note that the
blade bracket screws are pre-installed into
the blade bracket (Figure 15).
4. Repeat steps 1, 2 & 3 for the remaining
blades.
Blade
Figure 14