Installing The Light Kit /Glass Shades - HAMPTON BAY 186 977 Manual Del Propietário

Slot
Alignment
Post
Screws
Blade / Blade
Bracket Assembly
Installing the Light Kit
/Glass Shades
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Remove the four mounting screws and lock-
washers on the switch cup of the fan motor
assembly (Figure 16).
2. Connect the wires from the light kit as-
sembly to the wires from the switch cup of
the fan motor assembly by connecting the
molded adaptor plugs together.
3. Mount the light kit assembly to the switch
cup of the fan motor assembly by aligning
the four screw holes and securing with four
mounting screws and lockwashers that were
removed in step 1.
All manuals and user guides at all-guides.com
4. Route the pull chains from the switch cup
through the holes in the pull chains guide of
the light kit assembly.
5. With power off, install the two fluorescent
bulbs (Max. 14W, Supplied) by screwing
into the light bulb sockets.
6. Place the glass shade into the light kit
assembly, aligning the three flat areas on the
top flange of the glass shade with the three
raised dimples in the light kit assembly. Then
turn the glass shade clockwise until it stops.
NOTE: PERIODICALLY CHECK THAT
Figure 15
THE GLASS SHADE IS SEATED FULLY
CLOCKWISE IN THE LIGHT KIT
ASSEMBLY.
7. Attach the pull chain fobs provided to the
pull chains exiting the pull chain guide.
Switch
Cup
Blue
Black
Pull Chain
Guide
Pull
Chains
Fob Mounting
Light Kit
Screw (4)
Assembly
Raised
Dimples
Glass
White
Molded
Adaptor Plugs
White
Pull Chain
Guide
Pull Chains
Fob
Figure 16
Light Kit
Assembly
Bulbs (2)
(Provided)
Flat Area
Figure 17
9.