Relationship To The Authorities; Technical Data - Jøtul F 200 Instrucciones Para Montaje E Instalacion

UK - Installation and
operating instructions
Table of contents
1.0 Relationship to the authorities
2.0 Technical data
3.0 Safety
4.0 Installation
4.7 Requirement for UK - Smoke
control Areas
5.0 Daily use
6.0 Maintenance
7.0 Service
8.0 Operational problems -
troubleshooting
9.0 Optional equipment
10.0 Recycling
11.0 Guarantee terms
Register your fi replace at jotul.com for a
25-year warranty.
On all our products there is a label
Product:
Jøtul
indicating the serial number and
Room heater fired by solid fuel
year. Write this number in the
Standard :
Minimum distance to adjacent combustible materials:
Minimum distance to adjacent combustible materials:
place indicated in the installation
Emission of CO in combustion products
:
Flue gas temperature :
Nominal heat output :
Efficiency : instructions.
Operation range :
Fuel type :
Operational type :
The appliance can be used in a shared flue.
Always quote this serial number
Country Classification Certificate/ Approved by
standard
Norway Klasse II when contacting your retailer or
SP Sveriges Provnings- och
SP
Sweden OGC
Forskningsinstitut AB
Jøtul.
SP Swedish National
Testing and Research
EUR Intermittent EN
Institute
Follow user`s instructions. Use only recommended fuels.
Montage- und Bedienungsanleitung beachten.
Verwenden Sie nur empfohlenen Brennstoffen.
Respectez les consignes d'utilisation. Utilisez uniquement
les combustibles recommandés.
Lot no: Y-xxxx, Year: 200x Lot no.
Manufacturer: 221546
Jøtul AS
POB 1441
N-1602 Fredrikstad
Norway
1.0 Relationship to the
authorities
Installation of a fi replace must be according to local codes and
regulations in each country.
All local regulations, including those which refer to national
and European standards, must be observed when installing
75
the product.
The installation can only be put into use after it has been
75
checked by a qualifi ed inspector. Contact your local building
authorities before installing a new fi replace.
76
A product approval plate of heat-resistant material is to
be found in the ash pan. This contains information about
81
identifi cation and documentation for the product.
84

2.0 Technical data

85
Materiale
87 Finish
Fuel
88
Max, Log length
Recommended log length
Flue outlet
90
Flue pipe dimension
Outside air connection
91
Approx. weight for Jøtul F 200/F 205
Optional extras
91
Dimensions, distances
91
Technical data in acc. with EN 13240 / NS 3058
Nominal heat output
Flue gas volume
Chimney draught, EN 13240
Recommended negative pressure in
smoke outlet
Effi ciency
CO emissions (13% O
CO emissions (13% O
NOx (13% O
OGC (13 % O
Air consumption
Chimney temperature, EN 13240
Dust (13% O
Particle emission NS 3059
Fuel consumption
Max. kindling amount
Nominal kindling amount
Operation
Pin. *Intermittent combustion in this context means normal use of
the fi replace, i.e. fuel is added as soon as the fuel has burnt
down to a suitable amount of embers.
Cast iron
Black paint
Wood
37 cm
20-30 cm
Top, rear
Ø 150 mm
Alu. fl ex - Ø 80 mm
ca 138 kg
External air supply cover,
External air kit, short legs
See fi g. 1
5,0 kW
3,9 g/s
12 Pa
16-18 Pa
82%@5,0 kW
) 0,08 %
2
) 984 mg / Nm
2
) 99 mg / Nm
2
) 56 mg C /Nm
2
3,3 liter/sec.
269
) 14 mg/Nm
2
2,44 g/kg
1,5 kg/h
2,2 kg
1,5 kg
Intermittent*
ENGLISH
3
3
3
C
0
@13%O
3
2
75