Operational Problems - Troubleshooting - Jøtul F 200 Instrucciones Para Montaje E Instalacion

ENGLISH
Fig. 22a Replace the rear burnplate
OBS! Ash grate and side burner plates must be removed
fi rst
1. Carefully push the baffl e plate up to the rear edge (the
baffl e plate should not be lifted by the studs at the front
(see detail).
Fig. 22b
2. The rear burn plate is tilted forward and edged out of the
oven.
3. When reassembling, follow the same procedure in reverse
order (see fi rst fi gure 23, insulation mat).
90
Fig. 23 Insulation mat on rear burner plate
A
B
1. the insulation mat (A) is inserted into the groove on the
back of the burner plate (B), before carefully refi tting the
burner plate as shown in fi gure 22.
8.0 Operational problems -
troubleshooting
Poor draught
Check the length of the chimney and that it complies with
national laws and regulations. (See also «2.0 Technical
data» and «4.0 Installation» (Chimney and fl ue pipe) in the
installation manual for information.)
Make sure that the minimum cross section on the chimney is
according to «2.0 Technical data» in the installation manual.
Make sure that there is not anything preventing the smoke
gasses from escaping: branches, trees, etc.
Upon suspicion of excessive/poor draught in the chimney,
seek professional help for measurement and adjustment.
The fi re extinguishes after a while
• Make sure that the fi rewood is suffi ciently dry.
• Find out whether there is negative pressure in the house,
close mechanical fans and open a window close to the
fi replace.
• Check that the air vent is open.
• Check that the fl ue outlet is not clogged by soot.
Unusual amount of soot accumulates on
the glass
Some soot will always stick to the glass, but the quantity
depends on:
• Moisture in the fuel.
• The local draught conditions.
• Air vent opening.
Most of the soot will normally burn off when the air vent is
opened all the way and a fi re is burning briskly in the fi replace.