Avaya Integral E3 Montaje página 4

All manuals and user guides at all-guides.com
English
Wall mounted telephone – Integral E3
Follow the directions below on how to mount your Integral E3 telephone on
the wall. (The numbers in the text refer to the illustrations on the next page).
Caution: Electronic components can be destroyed.
Do not touch any electronic components. Pay attention to the
handling when working with electrostatically endangered
components.
1. Remove all cables from the telephone (incl. handset cable).
2. Separate the cover from the main body: Pick the telephone up with the
rear, raised side pointed upwards (illustration right). Using your thumb,
press firmly in the middle of the upper part of the main body (a).
At the same time, pull the cover and the main body apart (b).
3. Remove the socket cover: Press both thumbs simultaneously
against the inner indentations (4) on the socket cover (5), unlatch it
and press it outwards (illustration right).
4. Turn the main body 180° (raised side below). Position it on the wall.
Mark the drill holes through the holes of the main body (1, 7).
5. Drill the holes for the desired screws and wall plugs (e. g. wall plug ∅ 6 mm
and screw type – particle board, half round, recessed head (2.692.165.127)
SR 4.0 x 45 mm).
6. Guide the long side of the handset cable into the right cable canal (2) on the main
body.
7. Remove the outer insulation from the telephone cable (at least 10 cm). Place it in a
cable canal (3), in such a way that there is at least a 10 cm-long end.
8. Use the long hole (7) to correct the vertical position of the main body and fasten it
firmly.
9. Unscrew the fixing screw (9) of the handset cradle (10) from the cover. Remove the
handset cradle from the cover.
10. Place the handset cradle in the opposite direction back into the cover: The hook for
the handset (13) must be fixed into the handset cradle opening a (12) and the holder
(14) must be fixed into the handset cradle opening b (11).
11. Screw the handset cradle firmly.
12. Remove the terminal screw (17) from the multipoint connector.
13. Connect both of the wires of the telephone cable to the terminals screw.
Be sure that the telephone cable is never kinked or pressed on components.
14. Replace the terminals screws back onto the multipoint connector (position is unique)
15. Place the cover with the lower indentation (18) underneath the main body.
16. Put the handset cable into the handset socket (15).
17. Press the cover upwards against the main body until the upper indentation (8)
latches.
4.999.071.832 S 0802 S de S gb S es S fr S it S nl
a
b b