Switching The Appliance On And Off; Starting And Stopping The Cooking Cycle; Lengthy Downtimes Of Appliance - Angelo Po FC 611 G Manual De Uso E Instalación

4)Humidity setting knob: to set the percentage of humidity
Turn the knob clockwise to increase the value and anti-
clockwise to decrease it.
5)Thermometer: during cooking it shows the value of the tem-
perature inside the oven.
6)Oven malfunction light: comes on to indicate an appliance
malfunction requiring technical work to restore normal oper-
ation.
7)Mains light: comes on to indicate that the electricity supply
is on.
8)Gas malfunction light: comes on to indicate a gas system
malfunction requiring technical work to restore normal oper-
ation.
9)Temperature light: indicates that heating of the oven is in
progress, goes out when the set temperature is reached.
SWITCHING THE APPLIANCE ON
AND OFF
To carry out this operation, proceed as follows.
Lighting
1- Operate the ap-
pliance's master
switch to con-
nect it to the
A
electrical mains.
2- Turn on the gas
supply tap (A).
3- Turn on the wa-
ter supply tap.
4- Turn the knob
(B) clockwise (1
setting) to turn
on the appli-
B
ance).
Turning off
Important
Always switch off the appliance after use.
1- Turn the knob (B) anti-clockwise (0 setting) to turn off the
appliance.
2- Turn off the gas supply tap (A).
3- Turn off the water supply tap.
4- Cut off the mains electricity supply using the appliance's
master switch.
STARTING AND STOPPING THE
COOKING CYCLE
To carry out this operation, proceed as follows.
Important
Before performing a cooking cycle, the chamber must
be warmed up by carrying out a cycle empty.
At the end of the cycle the appliance shuts down and
a buzzer sounds.
Starting
1- Switch on the ap-
pliance (see page
5).
2- Turn the knob (3)
clockwise and set
a cooking time of
15÷20 minutes.
4/3 3- Turn the knob (2)
clockwise and set
a cooking temper-
ature
higher than the
required tempera-
ture, then perform
a cooking cycle
with no food in the
oven.
4- Turn the knob (4)
to set the percent-
age of humidity:
IDM-39614000300.tif
Stopping
The cooking cycle stops automatically at the end of the set time
and a buzzer sounds.
1- Turn the knob (1) anti-clockwise (0 setting) or open the door
to interrupt the cooking cycle at any moment.
LENGTHY DOWNTIMES OF
APPLIANCE
If the appliance is to be out of use for a lengthy period, proceed
as follows.
1- Turn off the gas supply tap.
2- Cut off the mains electricity supply using the appliance's
master switch.
3- Clean the appliance and the surrounding areas thoroughly.
4- Spread a film of edible oil over the stainless steel surfaces.
5- Carry out all the servicing procedures.
6- Cover the appliance and leave a few gaps to allow air to cir-
culate.
- 5 -
40÷50°C
4/4
1
2
3
4
IDM-39614000200.tif
IT
GB
DE
FR
ES
4/5
English