Light Bulb Replacement - Sears Kenmore 58642 Manual De Uso Y Cuidado

Light Bulb Replacement
I WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb, After replacing
light bulb, connect power.
CAUTION
To avoid personal injury or property damage, observe
; the following:
Allow light bulb to cool.
;, Wear gloves when replacing light bulb
Upper Fresh Food and Non Dispensing Freezer
Section
• Remove light bulb cover by removing ¼" hex nut
screws. Replace bulb with 40-watt appliance bulb
• Replace light bulb cover by replacing ¼" hex nut
screws.
Light bulb cover'
i
Lower Fresh Food Section (Some models)
• Remove light bulb cover by removing screw, Replace
bulb with 40-watt tubular bulb,
• Replace light bulb cover by placing cover over light
bulb. Insert and tighten screw°
Light
Freezer Section
1.. Remove ice bucket by lifting bucket and pulling ouL
2. Remove light bulb cover by removing 1/4"hex nut
screw. Replace bulb with 40-watt appliance bulbo
3 Replace light bulb cover by holding cover in place
over light bulb_ Insert and tighten screw.
4. Replace ice bucket by sliding in until bucket locks in
place
Ice 'N'Water
TM
Dispenser (Some models)
Light bulb is located between dispenser arms.
, Remove light bulb by unscrewing light bulb_ Replace
light bulb with a 6=watt, 120-volt bulb.
° Replace light bulb by inserting and tightening bulb.
r-1 0
I ..... i !
I
-- i
Ice 'N' Water
Dispenser
16