BQS BTG 0123 Manual De Uso página 31

2. Turn the seat over and unfold the group 0+ height adjuster decive
3. Place the seat in the back seat of the vehicle in opposite direction of travel.
4. Take out the reducer cushion . Pass the abdominal strap of the seat belt
through the lower seat guides
seat belt until you hear a click (fig. 4.1).
5. Pass the diagonal section of the seat belt through the upper guide (K) as shown
in fig. 4.1.
6. Take up the remaining slack of the diagonal section of the 3-point seat belt and
make sure it is as tight fitting as possible (fig. 4.2). Ensure the straps are not
twisted or knotted at any point (fig. 4.3).
7. Place the reducer cushion in his original place.
5. PLACING THE CHILD IN THE SEAT . GROUP 0+/ 1.
NOTICE
1. Press the harness adjuster button
straps that cross the chest in order to loosen them ( fig. 5.1). Do not pull the
shoulder protectors.
2. Release the buckle by pressing the button
child.
3. Place the child in the safety seat.
4. Secure the child in the harness by joining the two parts of the clasp /fig. 5.2/A)
and fastening the buckle
5. Pull the harness adjustment strap
to the child's body (fig. 5.4).
IMPORTANT!
The part of the harness straps that crosses the abdomen should be
placed as low as possible on the child's hip.
6. Pull down on the shoulder protectors
7. Make sure the headrest fits the child's height, otherwise adjust the headrest
height as shown in fig. 5.5 and 5.6.
(O)
and underneath the seat. Buckle the vehicle
GROUP 0+/1.
From 0 to 4 years approx. (0 - 18 kg)
(I)
while pulling the part of the harness
(D)
5.2/B) until you hear a click (fig. 5.3).
(H)
in order to tighten and adjust it correctly
(D)
(E)
to make it easier to seat the
to ensure they are properly in place.
www.babyqs.com
(Q)
(fig.3.6).
31