BQS BTG 0123 Manual De Uso página 32

6. INSTALLING THE CHILD SEAT FORWARD FACING. GROUP 1
NOTICE
1. Pull the lever
WARNING!
once the car seat is installed, if you change the recline position, you
should repeat the car seat installation steps described below to ensure a proper
installation in this new position.
2. Place the seat in the back seat of the vehicle in the direction of travel.
3. Pass the vehicle seat belt through the slot on the side of the safety seat
until it appears at the exit, in the other side (fig. 6.2). Buckle the vehicle seat belt
until you hear a click (fig. 6.3).
4. Take up the slack by pulling the abdominal section of the belt until it is as tight-
fitting as possible.
5. Pass the diagonal part of the seat belt through the guide
seat as shown fig. 6.4 .
6. Take up the slack of the diagonal part of the car belt as much as possible and
ensure the straps are not twisted at any point (fig. 6.5).
7. CAR SEAT INSTALLATION FORWARD FACING. GROUP 2/3
NOTICE
7.1 Removing the buckle and the 5-point harness
1. Press the harness adjuster button
straps that cross the chest in order to loosen them ( fig. 5.1). Do not pull the
shoulder protectors.
2. Loosen the harness straps from the back of the seat, freeing them from the
harness connector
3. Pull the harness straps from the front to free them from the seat back (fig. 7.2).
4. Turn the seat over and, from the back, take off the harness straps and free the
(E)
belt buckle
7.3).
5. Remove the belt buckle (fig. 7.4) and the harnesss straps and save them in the
storage bag.
32
GROUP 1 only.
From 9 months to 4 years approx. (9 - 18 kg)
(G)
forward and adjust the angle of recline to position 1, 2, or 3.
GROUP 2 /3.
From 4 to 12 years approx. (15- 36 kg)
(N)
(fig. 7.1).
by passing the retention plate through the slot in the seat (fig.
(I)
while pulling the part of the harness
(M)
(K)
at the top of the
BTG 0123