Electromagnetic Immunity - SybronEndo miniEndo Instrucciones De Empleo

Electromagnetic immunity

The product is intended for use in the electromagnetic environment specified below. The customer or the user of the product should assure that it is used
in such an environment.
Immunity test IEC 60601 Test level
Electrostatic discharge ± 6 kV contact
(ESD) ± 8 kV air
IEC 61000-4-2
Electrical fast transient ±2 kV for power supply lines
/ burst
IEC 61000-4-4
Surge ±1 kV differential mode
IEC 61000-4-5
Voltage dips, short <5 % U
interruptions and volt- (>95 % dip in U
age variations on power 40 % U
supply input lines (60 % dip in U
IEC 61000-4-11 70 % U
(30 % dip in U
<5 % U
(>95 % dip in U
Power frequency (50/60 3 A/m
Hz) magnetic field
IEC 61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
FB-128_ed_2007-05_miniEndo.indd 55
Compliance level
± 6 kV contact
± 8 kV air
±2 kV for power supply lines
±1 kV differential mode
<5 % U
T
) for 0.5 cycle (>95 % dip in U
T
40 % U
T
) for 5 cycles (60 % dip in U
T
70 % U
T
) for 25 cycles (30 % dip in U
T
<5 % U
T
) for 5 sec (>95 % dip in U
T
3 A/m
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic mate-
rial, the relative humidity should be at least
30 %.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typi-
T
) for 0.5 cycle cal commercial or hospital environment. If
T
the user of the product requires continued
T
) for 5 cycles operation during power mains interruptions,
T
it is recommended that the product be pow-
T
) for 25 cycles ered from an uninterruptible power supply
T
or a battery.
T
) for 5 sec
T
Power frequency magnetic fields should be
at levels characteristic of a typical location in
a typical commercial or hospital environment.
55 55
8/14/2015 12:36:23 PM